![]() Push the DIN tool outwards to close the clips on the radio inwards. Insert the ends of the DIN tool into the holes. How to Install a Radio in a 1999 Ford Explorerįind the two small holes that are located on each side of the radio. ![]() Hold the replacement stereo next to the dash and plug the harness and antenna lead into the back of the stereo, then slide the stereo into the dash kit until it clicks into place. Plug the vehicle-specific wiring harness into the factory harness. Push the dash kit into the dashboard and then pull the vehicle's wiring harness and antenna lead out through the cage. Match up the same color wires in each harness and join them together using the wire crimpers. Each wire in each harness is color-coded and labelled. Take the harness that comes with the replacement stereo and use the wire strippers to strip a 1/4 inch of shielding from the end of every wire in the harness. Then use the wire crimpers to crimp a blue butt connector onto each connection. Place the vehicle-specific wiring harness in one hand and use the wire strippers with the other hand to strip a 1/4 inch of shielding from the end of every wire in the harness. Place the cage that comes with the replacement stereo into the opening on the vehicle-specific dash kit and lock it in place by pushing down the tabs on the cage using a flat head screwdriver.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |