Run the interface interface-type interface-number.subinterface-number command to create a subinterface and enter the subinterface view.ī. Run the quit command to return to the system view.Ī. Run the portswitch command to switch the 元 Ethernet interface mode to L2 Ethernet interface mode.Ĭ. Run the interface interface-type interface-number command to enter the interface view.ī. Switch the 元 Ethernet interface mode to the L2 Ethernet interface mode.Ī. Run the system-view command to enter the system view.Ģ. You can configure the VLAN communications through L2 subinterfaces as follows:ġ. The system can forward traffic between different VLANs by terminating the VLAN at the subinterface. You can configure subinterfaces for L2 Ethernet interface and L2 Eth-Trunk interface. The IP addresses of the subinterface and the main interface can be in the same network segment, but the subnet masks of the subinterface and the main interface must different. Run the ip address ip-address command to configure the IP address for the subinterface. Run the interface interface-type interface-number.subinterface-number command to access the Ethernet subinterface view.ģ. Run the system-view command to access the system view.Ģ. Configure the Layer 3 Ethernet subinterface as follows:ġ.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |